Remko MKT 240 Manuel d'utilisateur télécharger pdf (Page 3)

3

Delivery

All devices are carefully packed

before shipping. Please check the

device immediately after delivery.

Make a note of any damage or

missing parts on the delivery note

and inform the forwarding agent

and your contractual partner. No

warranty can be assumed for later

complaints.

Erecting the device

■

Make sure that all air intake

and air outlet openings are

free; observe the minimum

clearances (Fig. 2).

■

Erect the device on a solid,

even foundation (Fig. 3).

■

Make sure that people and

sensitive objects such as plants

are not directly affected by the

emerging air.

■

Connect the device to a

properly installed plug socket

(230V/50Hz) (Fig. 5).

■

Insert the batteries into the

remote control. To do so,

push up the cover on the back

side of the remote control

and insert the batteries while

observing the proper polarity.

Observe the marking inside

the compartment (Fig. 6).

■

Check whether the plug of the

condensate drain spout has

been provided and whether

it has been properly inserted.

There is otherwise a danger of

water emerging.

Exhaust air conduction

During the operation of the air

conditioner, the device creates

humid exhaust air that must be

conducted outside of the room

so that the cooling effect can be

maintained.

Observe the following notices:

■

Plug the air outlet hose in-

cluded in delivery onto the air

outlet on the rear panel of the

device.

■

Lock both catches on the air

outlet into both openings of

the air outlet hose.

■

Keep the air outlet hose as

short as possible (max. length

1400 mm).

■

Always lay the air outlet

hose with a constant upward

incline from the device to the

wall/window.

Make sure it has

a wide curve radius (Fig. 7).

■

The air outlet hose may not be

extended.

■

Pivot-hung windows

·

Connect

the air outlet hose to

Connect the air outlet hose toConnect

the window jet and the de-

vice.

·

Op

en the window a

nd l

ay

the

ﬂ at nozzle between the win

dow trim and the window

frame

(Fig. 8)

.

■

Double-wing window

Lay the ﬂ at nozzle between

the wings, close the window

as far as possible, and secure

the wings with a holding strap

(Fig. 9).

■

Wall bushing

In case of permanent instal-

lation (s. p. 9, Fig. 19), the

exhaust air from the device is

conducted outside the room

through the wall bushing (Fig.

10).

Device Structure

Fig.

8

Hanging

the window jet

into a pivot-hung

window

Fig.

9

Secure the double-wing

window using a holding strap.

Fig.

10

Permanent installation

with a wall bushing (accessory,

not included in supply schedule)

Fig.

3

Vertical erection on

solid, even foundation

Fig.

4

Five-minute “wait“

Fig.

5

230 V / 50 Hz

Fig.

6

Remote control

6

Remote control

6

Abb.

7

Attach the air outlet

7

Attach the air outlet

7

hose with a constant upward

incline

1 2 3 4 5 6 7 8 ... 11 12

Commentaires sur ces manuels

Pas de commentaire